Airflow milling and operation: Before use, check whether all fasteners of the machine are tightened. Check that there is a hard debride in the machine pulverized chamber. Boot, confirm that the operation is normal, and the material is placed from the material port. When the discharge is running, it is strictly forbidden to extend the hand into the outlet of the discharge. The hierarchical impeller speed cannot exceed the specified value, otherwise the grading wheel is destroyed, the motor. The safety valve must be regularly verified.A bearing in the airflow pulverizer, which is the maintenance work? What are the specific reasons if the crusher is blocking this fault problem? Bringing these two questions, the main purpose is to make a good solution, so that everyone can clearly understand, and in practice, know how to deal with and quickly solve, rather than unknown.
Maintenance and maintenance of bearing in the pulverizer
For pulverizer, the bearing, the entire load of the equipment Therefore, the quality is good, and whether the rollover state is good, it is related to the life of the bearing, which affects the service life of the crusher equipment, so it should be paid attention to, where the mill manufacturer will remind everyone.
In the use of lubricants, its main requirements are: the lubricating oil used, must be cleaning and quality, if the quality is unqualified, or if there is impurities, Resolutely can't be used.
The lubricating portion of the airflow pulverizer is summarized, and it is, which is a rotating bearings, roll bearings, active bearings, gears, and sliding planes. This is not possible for these.
ALPA Powder Technology has been born in 20 years, has been adhering to the scientific management model of modern enterprises, adheres to "piety, fine, strict, harmonious" as the spiritual concept, and pursue excellence, casting dawn brand, revitalize the nation Industry "as a result of strong development purposes.
