ALPA gas flow grinding closed negative pressure, low temperature crushing, high purity operation, no dust pollution, system discharge is less than 5 mg / m3. The pulverized chamber is equipped with an automatic slag device that automatically eliminates difficult particles and impurities in the material. The reunion material has a dispersion and dispersion. The air of the large flow means that cooling polishing can be used for thermal material processing, no deposition. Automation control, low noise, no dust pollution.The pulverizer is blocked is one of the common faults in the use of airflow pulverizer. It is possible to be a problem in design, but more due to improper use of operation. The following Shandong El Pie Powder Technology Co., Ltd. summarizes the most prone to three failures.
1, the feed speed is too fast, the load is increased, resulting in clogging. During the feed, pay attention to the current table pointer deflection angle, if the rated current is exceeded, indicating that the motor is overloaded, and the motor will be burn down the motor. This situation should be reduced or closed immediately, or the feed is changed, and the feed amount is controlled by increasing the feeder. The feeder has manual, automatic, and the user should select the appropriate feeder according to the actual situation. Due to the high speed of the pulverizer, the load is large, and the fluctuation of the load is strong. Therefore, the current at work at the time of milling is generally controlled around 85% of the rated current.
2, the discharge pipe is not smooth or the feed is too fast, which will cause the crushing machine to block the air outlet; if it matches the delivery device, it will cause the discharge pipe wind to reduce or caught the wind. After the failure, you should first clear the delivery device that does not match the delivery, adjust the amount of feed, so that the equipment is operating normally. 3, hammer pieces, aging, screen hole closed, tattered, pulverized material water content will cause pulverizer to block. The broken and severe aging hammers should be updated regularly, keep the crusher's good working condition, and regularly check the screen, the water content of the powder should be less than 14%, so it can improve production efficiency, but also make the pulverizer do not block, Enhance the reliability of the milling machine.
In recent years, the attention of green and environmental protection and sustainable development has been mentioned unprecedented, whether it is Ningde era, AlPa powder technology is constantly practicing the concept of sustainable development. In the future, there is still an infinite challenge, but as a large-scale enterprise that shoulders social responsibility, AlpaPowder Technology will continue to adhere to technological innovation, and join hands with partners to achieve economic benefits, environmental benefits and social benefits.
