The problem of ordinary ultra-micro gas flow is: high manufacturing cost, large investment, high energy consumption, too much powder processing, so that it is also subject to certain fields; difficult to make submicron Level products, product particle size is best in 10 um, and the output is sharply decreased at 10 um, and the cost is rapidly rising; the single-machine handling capacity of gas flow is smaller (both less than 1 ton hour, can not adapt to large-scale production needs; Device machining accuracy and material wear problems still plague equipment manufacturers and factory users.
is a relatively mature ultrafine pulverized Equipment, unlike other devices, the principle of pulverization is to use high-speed airflow with animal particles, so that the materials are impact, collide, friction, and airflow to smash the shear of the material into fine particles. The airflow pulverizer is widely used Ultrafine pulverization processing of powder raw materials, the pulverization process is continuous, high in capacity, high automation, and due to small particle size of the processing, the particle size distribution is narrow, the purity is high, the particle activity is good, the dispersibility is good, especially suitable for most The processing of ultrafine powder.
The airflow pulverizer is the same as all mechanical equipment, and must be used through a series of strict tests. How to conduct a correct inspection work on the gas flow crusher? You will start from the following five aspects:
1. When the newly installed airflow pulverizer is in place and the warehouse to be pulverized, it will inevitably residual iron _x0005__x0005_-, electrode head, welding slag and other foreign matter. In not open In the case of the fan and main motor _x0005__x0005_-, open the unlocking baffle below the entrance to discharge impurities and cleaning materials there.
2. After normal check, open the device power supply. Check the direction of rotation of all motors. 3. Check if the solenoid valve is normal, and adjust the pulse width and injection interval of the dust collector solenoid valve.
4. Check if there is a leak in the brake cylinder brake. You can put your hand or fine powder On the interface, check if there is any suction sense. If there is, it must be sealed. After all of the above check is normal, the strip production is prepared.
5. Classification of two inverters and airflow milling machinesThe wheel motor performs parameter check, check whether the air volume of the motor, the contactor, the hot relay, and the overcurrent relay are suitable for adjustment. Return again.
The above is five aspects of the airflow crusher need to test before use. Do you have any gains? There are more consultations on the airflow pulverizer, please continue to pay attention to Shandong Erp, we will update your company's dynamics, welcome users to inquire.
Since the reform and opening up, China has adhered to the basic national policy of opening up to the outside world. Open the national door to engage in construction, and gradually form an external open pattern in the whole multi-level wide area. The relevant leaders of the state have also said: "Comprehensive development of the world's development trend, economic globalization is the trend of the era of irreversible." Shandong Alpa Powder Technology Co., Ltd. As a professional powder equipment manufacturing enterprise, the Dongfeng of the policy is formed. Sales network throughout the world, with a number of overseas companies, products are exported to Australia, South Africa, Indonesia, Arab, Thailand and other regions.
